How to Repair Broken Concrete Steps in Albuquerque, NM Worker
Here are some tips on how to repair broken concrete steps:
- Use building forms to hold the patching material in place while it hardens. A 2″ x 6″ board works well.
- Stack them against the damaged step. You might need more than one building form to cover the outer edges and corners.
- Mix a small amount of patching compound with water, then apply it to the steps.
The cement mix must be allowed to dry before you can proceed. The process could take up to a day, so make sure to tell anyone who lives in the home. If possible, rope off the area until the repair is complete. Make sure to follow all local codes and use protective gear. Consider installing an extension cord if your steps are in a residential area. If the cement is wet, connect it to a GFCI extension cord. Once you have a water supply, you can cut the concrete in grid patterns. Afterward, you can break off the surface to create a cap. The minimum thickness of the cap should be 3/4 in. Generally, thicker is better.
Once the patch has dried, apply a concrete resurfacer to the surface. A tangible resurfacing product has a rapid curing effect. This process is easy and inexpensive compared to constructing new steps. To avoid any injury risk, ensure the area is clean and free of debris. Remember that concrete sets quickly and becomes hard to touch in just ten minutes. Make sure you plan the repairs thoroughly before mixing the concrete.
After preparing the concrete resurfacing, you need to ensure the wood form is flush with the step’s surface. You can secure the form using duct tape. You may also need to connect it with a large stone or brick. Afterward, use a level to make sure that the concrete is level. This will prevent the cement from adhering to the old concrete. If you have poured the concrete, it will dry out within 24 hours.
The next step is to prepare the steps for the new cement. If you have a steep degree, you may want to use a wood form. The form should be flush with the step’s side and rise an inch above the top of the action. For corner steps, use an “L”-shaped form. Be sure to use cooking spray on the plywood form to avoid sticking to the new cement. When you have finished the steps, you can move on to fixing the cracked driveway.
If you have minor damages, you can resurface the steps. A concrete resurfacing method is recommended for more severe injuries, such as chipping and cracks. To repair your efforts, you can purchase wooden forms and masking tape. You can mix up the Bondcrete and water 1:10 with a 4:1:10 ratio. After preparing the wooden structures, you can apply the concrete to the steps and smooth it as it hardens.